Briggs & Stratton Standby Generator Systems Betreibershandbuch PDF herunterladen (Seite 37)

Antenna Installation

The supplied antenna must be installed before the wireless

monitor will operate.

1. Insert key into lock of front panel. Gently push down

on roof above the lock to aid in turning the key. Turn

key one quarter turn clockwise.

2. Lift roof to the open position.

3. Carefully push out the plug (A) located on the inside of

the roof.

4. Unscrew flange nut (B) from antenna post and

remove from antenna wire.

5. Route antenna wire (D) from the top side of the roof,

through the hole in the roof where the plug was

removed.

6. Replace flange nut on wire. Ensure the wire is routed

through the washer end.

7. Secure antenna to roof with the flange nut.

8. Locate wire connector (C) coming from control panel

and connect to the wire coming from antenna.

9. Route wire and secure with supplied cable ties (E) .

10. Close and open the roof to ensure the antenna wire

experiences no chaffing or pulling.

NOT

for

REPRODUCTION

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 43 44

Keine Kommentare

Briggs & Stratton Standby Generator Systems Betreibershandbuch Seite 37